[Mimedefang] Help with SA within MD
Mark G. Thomas
Mark at Misty.com
Fri Jun 15 12:56:06 EDT 2007
Hi,
This sounds a little like what happens with SpamAssassin-3.2.0 on
my systems, as per my last post. Did you have the problem with 3.1.8,
or did it just start happening with the upgrade to 3.2.0 ?
Mark
On Fri, Jun 15, 2007 at 12:44:21PM -0300, scuba at centroin.com.br wrote:
> Hi all,
>
> Something strange is happening with one of my MD boxes.
> Maybe it should best addressed in a SA list, but as far as it's
> used with MD, maybe someone could help me.
>
> The problem is that when I enable SA in mimedefang-filter, the
> multiplexor takes a lot more time to finish the message scan, and the
> server starts to swap.
>
> I.e: The normal (removing "spam_assassin_check()" from filter)
> average/scan is about 290 ms with one or two salves busy.
> With SA enabled, the scan takes from 30s to 70s. The number of
> slaves hits the maximum.
> Disable bayes checks, and set localtestonly, doesn't make
> difference.
>
> I would like some clue on how to track/debug this behavior.
> I have two boxes with the same setup, but only one has the
> problem.
> My config is as follow:
> FreeBSD 5.4, 1GB RAM.
> MD 2.61
> SA 3.2.0 (upgraded yesterday from ports)
> PERL 5.8.5
>
> The host that does not have the problem, is running FBSD 6.1 and
> Perl 5.8.8, that's the basic difference.
>
> - Marcelo
>
> _______________________________________________
> NOTE: If there is a disclaimer or other legal boilerplate in the above
> message, it is NULL AND VOID. You may ignore it.
>
> Visit http://www.mimedefang.org and http://www.roaringpenguin.com
> MIMEDefang mailing list MIMEDefang at lists.roaringpenguin.com
> http://lists.roaringpenguin.com/mailman/listinfo/mimedefang
--
Mark G. Thomas (Mark at Misty.com)
voice: 215-591-3695
http://mail-cleaner.com/
More information about the MIMEDefang
mailing list