[Mimedefang] Relay: Reject emails after receiving DATA negative result code from destination host?

[Benoit Panizzon]

Am Mittwoch, 18. Oktober 2006 14.58 schrieb David F. Skoll:
> Benoit Panizzon wrote:
> > Is there a way to delay the 200 Queued message until I get the
> > return code to 'DATA' from HOST B to pass this code to HOST A?
>
> Yes.  You need to run your Sendmail in "interactive" delivery mode.
> This may have other (undesired) side-effects, though.  Check the
> Sendmail documentation.

Hi David

This sounds very promising. I did try turning it on, but still haven't figured 
out in which filter part (where exactly in mimedefang-filter) I then can 
react to the 'data' result.

Regards

Benoit Panizzon
-- 
I m p r o W a r e   A G    -    System Services
______________________________________________________

Zurlindenstrasse 29             Tel  +41 61 826 93 00
CH-4133 Pratteln                Fax  +41 61 826 93 01
Schweiz                         Web  http://www.imp.ch
______________________________________________________