[Mimedefang] Relay: Reject emails after receiving DATA negative result code from destination host?
Benoit Panizzon
benoit.panizzon at imp.ch
Thu Oct 19 04:11:08 EDT 2006
Am Mittwoch, 18. Oktober 2006 14.58 schrieb David F. Skoll:
> Benoit Panizzon wrote:
> > Is there a way to delay the 200 Queued message until I get the
> > return code to 'DATA' from HOST B to pass this code to HOST A?
>
> Yes. You need to run your Sendmail in "interactive" delivery mode.
> This may have other (undesired) side-effects, though. Check the
> Sendmail documentation.
Hi David
This sounds very promising. I did try turning it on, but still haven't figured
out in which filter part (where exactly in mimedefang-filter) I then can
react to the 'data' result.
Regards
Benoit Panizzon
--
I m p r o W a r e A G - System Services
______________________________________________________
Zurlindenstrasse 29 Tel +41 61 826 93 00
CH-4133 Pratteln Fax +41 61 826 93 01
Schweiz Web http://www.imp.ch
______________________________________________________
More information about the MIMEDefang
mailing list